Step By Step Guide On Making A CD Case For D+T Resistant Materials Essay Example for Free

Step By Step Guide On devising A CD Case For D+T Resistant Materials Essay1. Find right equipment ruler, chisel, linchpin paper, glue, pine and ply2. Measure the right lengths of timberland and then cut into 4 separate parts 250mm for the lengths and 170mm for the widthsEquipment demand Ruler, saw, pencil3. Create a rectangle for the main frame- victimisation lap joints (250mm high and 170mm in width, sand if needed),4. Equipment needed chisel, hammer, glue and pencil5. Create long thin pine active 95mm long and 7mm high (so they look a bit like sticks) make about 12 pieces (6 ether side) to make the support for the CDsEquipment needed pencil, saw, ruler6. Glue the pine sticks to the inside of the frame making sure that nothing sticks out using sand paper, and also making sure that it only goes about 3/4 of the way down to leave space for the storage area.Equipment needed glue, sand paper7. Before sticking on the plywood make sure the CDs fit in between the frame nicelyEquipme nt needed CD8. making sure that nothing is sticking out and that the measurements are all correct glue the plywood on to the back of the pine frame.Equipment needed ruler, glue9. spine down any sticking out bits to make it look presentable.Equipment needed sand paper10. Sand the corners to make it aesthetically pleasing as possible.Equipment needed sand paper11. Then for a finishing touch add water based vanish.Equipment needed vanish